Page History

----
{center}
!CycleControls.bmp!
*CYCLE CONTROLS Panel*
{center}
-----

* {blue:Cycle Mode On}: Enables Cycle mode -- subsequently started [LOOP acquisitions|SI3.8_AcqModes] will follow the Cycle parameters configured in this panel.

* {blue:Cycle Name}: Name of Cycle file (.CYC), if any, that has last been loaded or saved
* {blue:Load}: Load a Cycle file (.CYC), updating current Cycle parameters. 
* (blue:Save}: Save current Cycle parameters to a Cycle file (.CYC). Dialog is launched to select the folder/file to save to.

(i) The current Cycle parameters are exactly those displayed in the {blue:Cycle Iteration Data} table

* {blue:Cycles Done}: On right, sets the number of Cycles to complete before automatically terminating the [LOOP acquisition|SI3.8_AcqModes]. On left, displays the number of Cycles which have been completed so far. In case of {blue:Auto-reset Iteration/Count} disabled, value at left can be edited to specify which Cycle count value to start with for next started [LOOP acquisition|SI3.8_AcqModes].
** For value > 1, Cycle wraps around to Iteration 1 following the final Iteration N. 
** For value Inf, Cycle wraps around indefinitely and never completes until user hits {blue:Abort} on the [Main Controls|Main Controls (r3.8)] panel. 

* {blue:Cycle Iteration}: On right, shows the number of _Iterations_ to be executed per-Cycle, i.e. the number defined in the {blue:Cycle Iteration Data} table. On left, displays the number of _Iterations_ which have been completed for the current Cycle count value so far. In case of {blue:Auto-reset Iteration/Count} disabled, value at left can be edited to specify which _Iteration_ to start with for next started [LOOP acquisition|SI3.8_AcqModes].

* {blue:Go Home at Cycle End}: If selected, the motor position is recorded at start of each Cycle-enabled [LOOP acquisition|SI3.8_AcqModes]. Upon completion or abort of the acquisition, the motor is moved to restore the starting position.

* {blue:Restore Original CFG}: If selected, the prevailing [Configuration|SI3.8_Config] is cached at start of each Cycle-enabled [LOOP acquisition|SI3.8_AcqModes] -- the active settings, not just the settings in the last-loaded [Configuration file|SI3.8_Config]. Upon completion or abort of the acquisition, the cached [Configuration|SI3.8_Config] settings are restored.

* {blue:Auto-reset Iteration/Count}: If selected, the 


h4. Cycle Mode Overview