...
The ScopeGUI is a specialized program for whole-cell recordings. It is primarily used to hunt for cells and to check cell parameters. With a model cell configured, run the scope to verify that Ephus communicates via the amplifier. Start and stop the scope. Change the gain and mode settings on your amplifier to test the connection between Ephus and the amplifer. Changing the mode settings in MultiClamp Commander should change the modes indicated in the scopeGUI.
| Warning | ||
|---|---|---|
| ||
It is important that the scopeGUI is turned off before proceeding with other data acquisition. Otherwise an error will occur! |
Program GUIs
Have a look at the menu bar of the XSG GUI. This menubar is shared by most other GUIs except programs related to the Oscilloscope. You can always use the 'Programs' menu to reactivate programs by clicking them.
...