Virtually conjugate galvo-galvo pair
Build alignment jig
Mount galvo mirrors on shafts
Setup alignment laser
Wire up and turn on galvos
Do alignment
XXXXX Prepare V-blocks — insert photo of parts with screws
IMOHolderAssemb
1) Add
Imaging objective mounting
Assemble imaging objective mount
Gluing kinematic mount
Assembling primary dichroic cap
Putting in spring plungers and set screws
Emission splitting dichroic assembly
PMT assembly
The goal is to couple the lens onto the PMT face with oil
Seal the edge of the PMT face to the PMT housing with 5 min epoxy - careful not to soil the plate above the photocathode
Add 30 - 50 ul of high viscosity oil
Place condensor lens on oil. Make sure there are no bubbles and carefully remove overflow oil from the housing.
Place a thin ring of quick seal (WPI) on the PMT housing around the lens
Assemble alignment jigs
Alignment jig cage assembly
Imaging objective alignment jig mount
...
Left, remote focus objective mount, quarter waveplate holder, quarter waveplate, and polarizing beamsplitter. Right, components mounted on remote focus mount, including remote focus objective.
Mounting the large relays 1, 2, and 3
Relays 1 & 2 require 1.5" 1/4 20 socket screwsRelays 3 requires 2.5" 1/4 20 socket screws
Mount as shown in the photos
Left, mounts for relays 1 & 2. Right, relay 3
Assembling the covers
Assembling objetive mounted optic holder
Accessory optics
1) Remove galvo mirrors from mount
Mounting galvo driver and resonant driver boards (Spencer / Steve documentation)
Making samples
Beads
Fluorescein
Accessory optics------------------
SECTION 2: MOUNT ON BREADBOARD
...