SECTION 2: MOUNT ON BREADBOARD
Mounting on the breadboard
Put dowel pins into holes
Mount brackets for PupilRealy3 first, make them pressed against the pins and their angled side facing down
Mount pupil relay 3, push so all the way to the left (edge against mounting surface). Tighten down clamps with screws with springs. Make sure nuts are in right place.
Mount IMOholder and tray, pushed it against the table and pins.
Mount primary dichroic, make sure caret faces down
Add primary dichro cap, pressing it against vertically mounted breadboard
Add bigDetLensHolderAssby - note need a 1/2 inch 10-24 screw to secure top right part
Add detLensCap
Mount the galvo block, pushing it against pins. Note there is not a lot of space between the galvo mirrors and pupil relay 3
Attached pupil relay 2 to the resonant chamber
Use long handle quarter-20 hex drive to mount resonant chamber to breadboard. Use paper trick to get screw sitting on ball end of hex drive, and then screw chamber down.
Attach pupil relay 1 mount to breadboard
Attach pupil relay 1
Attach remote focus objective assembly
Attach fold mirror assembly
Blow all dust out of resonant mirror chamber before sealing it up
Attach emisson splitting assembly
Attach PMT assembly, with PMT cover on. Have to thread cables through cover. Screw on filters to PMT assembly.
Attach periscope