ScanImage r3.7 standard_model.INI

Added

• : Specifies mapping of X/Y scanners to channels 0/1 on the board identified by .

• : See Support for shutter located before Pockels.

• : See Power Adjustment During Stacks.

• : Specifies which of the linear stage controller types is used – one of {'mp285', 'mpc200', 'scientifica'}

• : For some controllers ('scientifica'), the stage type connected to controller must be specified on initialization.

Next triggering is a new feature in ScanImage 3.7, with following new INI vars:

Frame/Line/Pixel clock export is a new feature in ScanImage 3.7, with following new INI vars:

Removed

• : Clock Synchronization is no longer configurable in ScanImage 3.7 – it must occur on RTSI7.
• : This setting is now a User Preference.

Modified

• renamed to . See detailed new notes in notes in standard_model.ini.

• renamed to – better identified as pertaining to a start trigger (as opposed to a Next trigger)

Values that are angles (in optical degrees) are clearly identified:

• renamed to
• renamed to

Several motor configuration values have initial values of empty ([]).

If these values are left as is, this signifies that ScanImage should use default value appropriate to specified .

Motor resolution/step size setting in units better matching vendor specification:

• modified to . See notes in standard_model.ini.This can be left un-edited to use the default resolution/step-size setting for controller (& stage) specified.

Board identifiers numbers now uniformly use 'ID' in their names:

• renamed to
• renamed to
• renamed to
• renamed to
• renamed to
• renamed to
• renamed to

Previous identifier 'Index' no longer used since values are typically not a number, but rather 'Dev##'